The KJT D12P series Differential Hall-Effect Speed sensors are suitable, in conjunction with a ferrous pole wheel, for generating square wave signals proportional to rotary speeds. They exhibit a dynamic function, whereby pulse generation down to 5 Hz is guaranteed. The sensor must be oriented with respect to the pole wheel as shown in the dimensional drawing (see spec sheet below).
Signal Output: Square Wave signal from push-pull output stage, DC-coupled to the supply, 30 mA max. load current
Thread Length: 1.9" M12x1 thread
8-32 DCV Supply Voltage
15 mA (without load) maximum current consumption
5-20 kHz Frequency Range
Housing: M12x1, tightening torque: max 12 Nm
Connection: Cable with Connector:
Cable: 3-wire, 3 X 0.21 mm2 (AWG24), 350 mm (13.75") length, stranded wires, PTFE isolation, green casing
Connector: AMP 282105-1, 3 pins
Operating Temperature: -104-257°F (-40-125°C)
Protection: IP68 (Sensor) / IP67 (Cable)
Insulation: housing and electronics galvanically isolated (Test: 500V, 50 Hz for 1 minute)
Digital Magnetic & Hall Effect Sensors
Hello, please leave your name and email here before chat online so that we won't miss your message and contact you smoothly.